Fast-Glue 1

Description

Fast-Glue is a fast drying ethyl-cyanoacrylate glue for the fast and durable gluing of difficult materials. The product is colourless, solvent-free and cures very quickly. Extremely handy in use because of its unique dispensing cap and locking system.

Fast-Glue is available in two finishes: Fast-Glue 1 and Fast-Glue 3.

Fast-Glue 1 is the low viscosity variant, perfectly suited to the repair of rubber and softer plastics such as (o-)rings, sealing rubbers, door rubbers and cracks in the interior trimming.

Fast-Glue 3 is the high viscosity variant. This is suited to the gluing of hard materials such as metal and hard plastics. Can be used to great effect, for example, in the strengthening of cracked drill holes and the gluing of broken clips.
Another advantage with the high viscosity of Fast-Glue 3 is that the product can be applied as a gel, so that it does not flow off the repair area like a super glue, but glues exactly where necessary.

Acti-Prim optimizes the adhesion of Fast-Glue 1+3 and accelerates the drying process.

Due to its handy packaging in 20 g bottles Fast-Glue is user-friendly and easy to apply. Due to the resealable, pointed nozzle the product can be dosed extremely accurately and has a long pot life.

Properties

• Easy to use.
• Quick drying.
• Suitable for various surfaces.
• Very accurate dosing.

Instructions for use

• Surface preparation: The surface must be clean, dry and free of grease. Clean surfaces with Innotec Multisol or Innotec Seal and Bond Remover. Clean plastic surfaces with Innotec Repaplast Cleaner Antistatic.
• Application method: Apply a small amount of glue on one of the surfaces to be bonded. Press the surfaces against each other and prevent shifting. With most materials, a glue bond is achieved within 10 seconds.

Technical information

• Base: Ethyl-cyanoacrylate
• Density: 1050 kg/m³
• Consistency: Liquid
• Viscosity: ± 30 mPa.s
• Flash point: > 85°C
• Temperature resistance: -60°C to +80°C
• Moisture resistance: Moderate. Not resistant to prolonged contact with water.
• Solvent resistance: Moderate
• Acid resistance: Resistant to most diluted and not diluted acids
• Dielectric constant: 4 with 50 Hz (cured)
• Electrical insulating resistance: 8.6 1012 ohm/cm (cured)
• Application conditions: +5°C to +25°C
• Type of surface: Soft materials like plastic and rubber
• Surface preparation: The surface must be clean, dry and free of grease. Clean surfaces with Innotec Multisol or Innotec Seal and Bond Remover. Clean plastic surfaces with Innotec Repaplast Cleaner Antistatic.
• Application method: Apply a small amount of glue on one of the surfaces to be bonded. Press the surfaces against each other and prevent shifting. With most materials, a glue bond is achieved within 10 seconds.
• Correction time: No correction time
• Drying time: Curing time and final strength depend on humidity and the surfaces to be bonded. The optimal relative humidity is between 45% and 65%.
• Filling capacity: < 0,1 mm (cured)
• Cleaning of materials used: With Innotec Multisol
• Cleaning of hands: With Innotec Power Scrubs or with Innotec Safe Hand Clean Plus and water
• Shelf life: 1 year in original, unopened packaging
• Storage conditions: Store cool and dry (5°C to 15°C)
• Type of batchcode: F
• EAN Code: 5400563001110