Filling Foam

Description

Filling Foam is part of the Innotec Velours Repair System. It is a filling foam used to help build up upholstery repairs.

See also: Velours Repair System

Properties

No product information available

Instructions for use

• Surface preparation: The surface must be clean, dry and free of grease. Clean upholstery with Innotec Remover and leave to evaporate for 2 minutes.
• Application method: Cut out the damaged section. Cut out a corresponding quantity of Filling Foam. Use this to fill the damage up to the back of the covering. Glue the Filling Foam on the bottom only using Innotec Base Glue. Do not press the Filling Foam down, to avoid differences in tension at a later stage. See the directions for use for Innotec Velours Repair System.

Technical information

• Base: Polyester
• Density: ± 26-30 kg/m³
• Dimensions: 15 cm x 15 cm x 10 mm
• Application conditions: +15°C to +30°C (Innotec Base Glue)
• Type of surface: Almost all modern upholstery systems
• Surface preparation: The surface must be clean, dry and free of grease. Clean upholstery with Innotec Remover and leave to evaporate for 2 minutes.
• Application method: Cut out the damaged section. Cut out a corresponding quantity of Filling Foam. Use this to fill the damage up to the back of the covering. Glue the Filling Foam on the bottom only using Innotec Base Glue. Do not press the Filling Foam down, to avoid differences in tension at a later stage. See the directions for use for Innotec Velours Repair System.
• Cleaning of materials used: With Innotec Remover
• Cleaning of hands: With Innotec Power Scrubs or with Innotec Safe Hand Clean Plus and water
• Shelf life: Unlimited in original, unopened packaging
• Storage conditions: No restriction
• EAN Code: 5400563025741